DIY Rubber Stamp Making Photopolymer Plate Craft Letterpress Polymer Sheet

DIY Rubber Stamp Making Photopolymer Plate Craft Letterpress Polymer Sheet
  • Sellersbsportsbook.com
  • List PriceUS$6.43piece
  • Sale PriceUS$6.43piece
  • ShippingFree Shipping
  • Ratings3,2 (663)

Product Description

Description:
DIY Rubber Stamp Making Photopolymer Plate can be used to make personal stamp easily.

Specification:
Material: Resin
Color: Light Green
Length: 30cm/11.8''
Width: 20cm/7.9''
Thickness: 1.6mm
Photopolymer Thickness: 1mm (40mil)


Features:
1.Photopolymer plates, or solar plates as they are also known, are used in the flexographic
printing industry. They have also been used by Artist Printmakers for many years, and can
be used to make personal stamp easily.
2.Making the plates is easy and can be done in the home, no harmful or dangerous chemicals
are needed and the equipment used is easily and cheaply obtained.

DIY Stamp Making Instruction:
1. Print the image that you want to use to create your photopolymer plate on a transparency
sheet using an inkjet printer. Cut a piece of photopolymer plate 1/4 inch wider and taller than
the design on the transparency sheet, using the metal shears. Trim the transparency to the
same size as the plate.
2. Cut the two pieces of clear acrylic the same size as the plate, using the metal shears. Remove
the protective film from the surface of the plate that will be exposed. Position the plate on one
piece of acrylic. Place the transparency on the surface of the photopolymer plate with the ink
side down. Place the second piece of acrylic on top of the transparency.
3. Place the clamps on each of the four sides of the acrylic, plate and transparency, to hold them
together. Place the entire assembly under an ultraviolet lamp. Set a timer for 1 minute.
4. Turn on the lamp and activate the timer. Turn the ultraviolet lamp off when the timer reaches the
set time. Remove the exposed plate and remove the clamps from it.
5. Place the exposed plate under 4 or 5 cups of clean water in a large plastic bowl. Brush away the
soft unexposed photopolymer from the surface of the plate using a soft nail brush. Hold the plate
under water and use a firm circular scrubbing motion.
6. Dry the plate using a hair dryer on low heat. Set the timer for 1 minute, and place the dry plate under
the ultraviolet lamp for a final hardening. Turn off the lamp and remove the plate.

Package Included:
1 x Photopolymer Plate



DIY Rubber Stamp Making Photopolymer Plate Craft Letterpress Polymer Sheet

DIY Rubber Stamp Making Photopolymer Plate Craft Letterpress Polymer Sheet

DIY Rubber Stamp Making Photopolymer Plate Craft Letterpress Polymer Sheet

DIY Rubber Stamp Making Photopolymer Plate Craft Letterpress Polymer Sheet

DIY Rubber Stamp Making Photopolymer Plate Craft Letterpress Polymer Sheet

DIY Rubber Stamp Making Photopolymer Plate Craft Letterpress Polymer Sheet

Similar Products